New Portable Baby Moniter Kit Consist Pink 2.4G 6 LED IR Day and Night 1/3 Inch Security CCTV Wireless CMOS Video and Audio Camera and Pink 1.5" Inch TFT LCD 4 Channels Monitor with Voice Controls Function for your home
7 levels of brightness control and low power supply.
9.
AV output jack.
10.
Automatic Infrared LEDs for Night Vision.
11.
Transmits up to 100m without any block.
12.
Portable and light weight.
Set Up The Camera:
Supply power by battery:
1.
Open the battery compartment cover on the rear of Camera.
2.
Insert the Li battery follow the plus+ and minus-, then close the batter cover.
3.
Press the power switch, the power indicate light on, put the channel set up on channel which need working (often have four channel).
4.
Please close let power off when not use the camera.
Supply power by power adapter:
1.
Plug one end of power adapter to the wall outlet and the other end into the plugof camera.
2.
Press the power switch, the power indicate light on (when supply power by AC adapter, if the battery haven't enough power then AC adapter can charge the battery automatically and the power indicate light on, when full charge the recharge power indicate light off (can recharge and working meanwhile).
Set Up the Monitor:
Supply power by Battery:
1.
Open the battery compartment cover on the rear of Monitor.
2.
Insert the Li battery follow the plus+ and minus-, then close the batter cover.
3.
Press the power switch, the power indicate light on, put the channel set up channel which need working (often have four channel). When observe the image by LCD you can through the A/V output and connect with AV input of TV or VCR monitor observe meanwhile.
Supply power by AC Adapter:
1.
Plug the AV power adapter to the DC input of the monitor, if the battery haven't enough power then the charge indicate light on, after charge full, the indicate light turn off automatically.
2.
Press the power button, and other function same as supply power by battery (can charge over observing).
Solve Trouble:
LCD or VCR no signal interpretation:
1.
Make sure the Camera or Monitor are turn on, and working indicate light are turn on.
2.
Make sure low power indicate light are turn off.
3.
AC power adapter and antenna whether it connect well, brightness whether turn into most dark.
4.
Whether the voice control turn to the lowest situation, or turn off the Monitor and turn on again, if have image can turn the voice control to higher situation or make sure whether there have voice from Camera side.
If the image isn't clearly or have interference interpretation:
1.
Whether there are other 2.4GHz products working or someone uses mobile phone in near place.
2.
Make sure the Camera away from monitor in limited distance area of each other.
Product Images
(1/7)
